Price:
$43.4

Free Shipping


Overview and Specifications:

Product Attribute
Compatible Brand/Model : Nintendo
Model Number : JYS-NS191
Interface Type : Bluetooth
Package : Yes
Origin : CN(Origin)

When connecting and pairing for the first time, please refer to the following steps:

1. turn on the Switch host
2. Install the handle on the Switch host. Slide the handle down from top to bottom by using the slideway on the side of the host until you hear a slight sticking sound
3. The handle starts to automatically register for pairing. After successful pairing, it can be inserted into the host for use or removed

Connect via Bluetooth to use:

Pairing cannot be registered after the handle is installed on the host. Please refer to the following methods to check the pairing problem:

1. Make sure your host has been upgraded to the latest system
2. Press the pairing key to close the handle, reset the connection of the handle, and then plug the handle into the host computer
3. Plug the handle into the host, make sure it is inserted in the right direction, slide to the end, and hear a slight sticking sound
4. Unplug the handle from the host and try to insert it again, eliminating that it can not be paired because of poor contact
5. If the handle cannot be awakened, please charge your handle and try pairing again

Note:

1. the switch host must be turned on. if the host is dormant or turned off, the handle cannot complete pairing

2. When the handle cannot be awakened or the LED indicator flashes slowly, please charge your handle before using it.

How to pair (reconnect) the handle to the switch host again

After the handle is initially paired, the handle can be connected to the host again in the following two ways

Mode 1 Bluetooth connection pairing
1. turn on the Switch host
2. Press any function key (except the rocker) for 2 seconds to wake up the handle, and then the handle will automatically connect with the host via Bluetooth, and the connection can be completed in about 4 seconds
3. Once the pairing is successful, the LED indicator corresponding to the handle is always on

Mode 2 Wired Connection Pairing

1. turn on the Switch host
2. Install the handle on the host through the slideway on the side of the host
3. After that, the handle will automatically connect and pair with the host by wire, and the connection and pairing can be completed in about 4 seconds

Paired question answer

When the handle is inserted into the host, it cannot be paired. Please refer to the following method to check the paired handle or method

Method 1: delete the pairing information of Switch host
1. in the main interface, select [settings], then click [handle and sensor] and select [disconnect from handle]
2. Press the X key of the handle for a long time to disconnect the host from all handles and unmatch
3. Pair all the handles that need to be used again
Method 2: Press the pairing key of the handle, reset the connection of the handle, and pair again
Remove the handle from the host, press the pairing key of the handle, reset the connection of the handle, and pair the handle to the host again
Method 3: ensure that the handle has been slid into the slideway of the host in the correct way, and slide the handle to the bottom
Method 4: Charge your handle, because the battery of the handle must be kept at low power during transportation
State, when you get the handle, the handle may be in a low power state and cannot be opened
Method 5: Make sure the host is the latest system
Method 6: Try to remove the handle from the host several times and then connect it